OK, back to work. I am looking to finish this sucker in the next couple of days, so here we go.......
Not much to put out on this post, but the panels are built and being primered. Now I know there are some of you that just cringed when you saw my panels. It's OK. Relax.... Breath in.... and remember this is a custom project.
So if you didn't notice, the faces of my panels were put in reversed. therefore everything is flip-floped as far as canon goes.
This was done because either
A) I put these in when I was too tired to be working.
B) It's a custom project and different is sometimes good
C) It proves that I built them myself
D) Sometimes it's the easiest things that trip you up in a project
E) All of the above
If you guessed E then you are correct. The reality is that once I noticed that they were put in reversed I had already built them. These panels were more work than the table itself and I was going to learn to like it as-is
Anyhow, more to come tomorrow
